Victron BlueSolar PWM LCD & USB 12/24V - 20A
Estimated Delivery 7 - 14 days
The BlueSolar Charge Controller series uses Pulse Width Modulation (PWM) charge voltage control combined with a multistage charge control algorithm.
- Voltage: 12/24V
- Rated Charge Current: 20A
- Protection Category: IP20
- Bluetooth Enabled: No
- Dimensions: 96 x 169 x 36mm
- Weight: 0.15Kg
- Warranty: 5 Years
Liquid crystal display
For status monitoring and set-up
Load output
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.
Some loads (especially inverters) can best be connected directly to the battery and the inverter remote control connected to the load output. A special interface cable may be needed please see the manual.
The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm
Preprogrammed algorithms for AGM GEL Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
-
-
-
-
BEP Ultrasonic Tank Sender (BULK)£128.54 £107.12 -
-
-
-
-
Simrad Single StructureScan 3D Stainless Steel Thru Hull£1,418.61 £1,182.17 -
Navico NSSevo3/3S & ZEUS³/³S 9 '' Edge£52.12 £43.43 -
-
